Halloween Place Card Holders to Make (1940’s)

Lot 20 Vintage Die Cuts Place Cards Halloween Art Deco.    US $12.06 VINTAGE 1930's HALLOWEEN Tally/Place Card w/Ghost/JOL    US $9.00 HALLOWEEN BETHANY LOWE FLYING WITCH HAUNTING PLACECARDS    US $9.95 DEPT. 56 ALL WITCHES EVE PLACE CARDS HALLOWEEN NIP    US $9.95 Halloween Place Card Holder Witch Hat Wicth Shoes 4/set    US $27.98 Halloween Place Card Holders NEW    US $2.49 24 LOT Halloween Grave place card holder Wedding Favor    US $24.90 HALLOWEEN CERAMIC TOMBSTONE PLACECARDS SET OF 4    US $10.00 NEW 6 RIP Tombstone Halloween Party Wedding Place Cards    US $3.07 Halloween Gothic Wedding party Favors table Place Cards    US $14.99 Halloween Gothic Wedding party Favors table Place Cards    US $22.49 Halloween Gothic Wedding party Favors table Place Cards    US $29.98

To make a spiral as a support for cut-out witches, cats, bats, pumpkins, ghosts, tombstones, etc... Use about 20 inches of wire for a 4-inch place card. Four inches from the end, bend the wire at right angles. One inch from this point bend sideways and start the spiral, holding the wire flat on the table with the 4-inch length extending straight up to insure a flat spiral. About three full circles will make a strong base. Wires may be wrapped with crepe paper if desired.

Post Footer automatically generated by Add Post Footer Plugin for wordpress.

Tagged with: place cards

Filed under: 1940's • Decoration Ideas

Like this post? Subscribe to my RSS feed and get loads more!